PCM Reflashing operations. A recalibrated PCM "tune-up" is loaded onto the brick via the USB cable, then the brick is plugged into the OBDII port. The ignition is turned on, and ~60 seconds later the RX-8 has a new tune-up in the PCM. The ignition is turned off, and the brick removed.
"Hands off" data logging. The brick is plugged into the OBDII port, and logs 2 hours of engine performance data. Commonly used tuning things like RPM, TPS, AFR, MAF, Coolant Temp, Load etc.
"Live Mode" for use with sCANalyser Live scan tool - displays up to 9 live gauges on the laptop (or carputer). CEL diagnosis and resetting. Other PCM monitoring functions.
sCANalyser Pro Tuner - This allows any calibration map to be altered by the tuner. Maps are displayed in "table" form (numerically) and via 2D or colored 3D charts for easy visualization. 3D Charts can be spun around to look from any angle to spot inconsistencies. The editing functions allow for "bulk" updates to be made to the table data by applying offsets and scaling to ranges of values, and performing smoothing functions over ranges of values. sCANalyser Pro Tuner is also use to save the modified calibration to disk for later re-use, and then written to the brick prior to the reflash procedure.
sCANalyser Pro Logger - This reads the logged information from the brick after it has been used in "hands off data logging" mode. The data is displayed graphically and numerically for analysis of performance / tuning modifications. The user can zoom in to see the data in detail.
sCANalyser Live USB - This used the brick in "Live Mode" (as above in #3) and acts as a scan tool providing live gauges (graphically very sexy!) and other traditional scan tool functions such as CEL diagnosis and resetting.
The only tool available today that works on RX-8’s worldwide.
sCANalyser "Live" USB Coming Soon (£124.20 Including VAT at 20%)
Understand how your engine is performing Understand how your engine is performing
Live gauge display View powertrain information such as engine speed, mass air flow and oxygen sensor readings in real time on digital gauges.
Data logging With the new fast mode (in version 1.1 beta) you can sample at approximately 50 millisecond intervals, generating up to approximately 120 samples per second
Vehicle information View vehicle information such as the VIN and calibration number (what version of the "flash" software is installed)
Diagnostic troubleshooting Access the list of diagnostic trouble codes (DTCs) that are stored when you have a check engine light, as well as any corresponding freeze frame data which capture what the vehicle was doing at the time of a problem Descriptions can be looked up from a text file that you supply
Test Monitoring View emissions related test monitoring results.
What do I get? sCANalyser is supplied with all you need to connect your computer to your vehicle via a 9 pin serial port: The supplied low profile right angle OBD connector helps keep the cable out of the way.
Minimum system requirements Minimum
Recommended system requirements Recommended
